Spring
washer
Retainer
nut
Key
Lock
Step 7: Install the door
Carefully open the top and bottom hinges on the door being
careful as there are many pinch points. Place the hinges
over the 4 screws in the cabinet, 2 at the top and 2 at the
bottom and slide the door into position. Tighten the 4 hinge
screws with a phillips screwdriver. (See Figures 13 and
13a). Place wire harness from the grille and mount to the
bottom of the door with the screw and "P" clamp removed
in step 1. (See Figure 13b). Reconnect the wire harness,
(See Figure 14).
OVERLAY DOOR PANEL INSTALLATION
Cam
Brass extension
(2 lengths provided
Set screw
Cam stop
washer
Figure 26
Screw
Step 8: Secure the cabinet
Use the #8 x
⁄
" black screws from the literature pack to
3
4
secure the counter top to the cabinet top through the holes
in the cabinet "Z" bracket.
Cabinet
"Z" bracket
#8 x
⁄
" black
3
4
screws
(3 places)
20
Figure 27