Marvel MP15BCG4 Série Instructions D'installation, D'utilisation Et D'entretien page 17

Step 5: Assemble lock parts
Two (2) lock extensions are provided with the lock. Use the
longer extension for ⁄ " thick overlay panels and the shorter
3
4
one for ⁄ " thick overlay panels. Assemble the lock exten-
5
8
sion, cam stop washer, spring washer, and set screw to the
lock as shown in Figure 23 and 24.
Install this lock assembly into the lock hole in the overlay
panel and secure with the retaining nut on the back side
with a 15 mm socket and ratchet. Make sure the key slot in
the front of the lock is vertical.
BRASS EXTENSION
SPRING WASHER
NUT
LOCK
1/2 HOLE
13/16 COUNTER
BORE 7/16 DEEP
3/4 INCH
WOOD PANEL
Step 6: Install lock cam
Attach the lock cam to the back of the lock assembly with
the phillips head screw provided. Orient the lock cam verti-
cally when installing on the lock.
Spring
washer
Retainer
nut
Key
Lock
OVERLAY DOOR PANEL INSTALLATION
CAM
PHILLIPS SCREW
INNER
DOOR
SECTION A-A
SCALE 1 : 1
Figure 23
Cam
Brass
extension
(2 lengths
provided)
Cam stop
washer
Set screw
Figure 24
Step 7: Install the door
Carefully open the top and bottom hinges on the door being
careful as there are many pinch points. Place the hinges
over the 4 screws in the cabinet, 2 at the top and 2 at the
bottom and slide the door into position. Tighten the 4 hinge
screws with a phillips screwdriver. (See Figures 11 and
11a). Place wire harness from the grille and mount to the
bottom of the door with the screw and "P" clamp removed
in step 1. (See Figure 11b). Reconnect the wire harness,
(See Figure 12).
Step 8: Secure the cabinet
Use the #8 x ⁄ " black screws from the literature pack to
3
4
secure the counter top to the cabinet top through the holes
in the cabinet "Z" bracket.
Cabinet
"Z" bracket
#8 x ⁄ " black
3
4
screws
(3 places)
Screw
Figure 25
17