Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5....-05-BQ 2849
Overview of the Components
1
Heating element
2
Thermostat
3
Control lamp
4
Grill tray
Please see illustration 1.
•
First remove the heating element (1).
•
Remove any packaging material that may be present.
•
Clean the grill grid (5) and the reflective metal sheet (7) with a moist cloth.
•
Turn the grill tray (4) upside down.
•
Use the threaded screws to attach the feet (8) to the grill tray (4).
•
Assemble the grill as shown in illustration 1.
•
Pour 1.5 litres of cold water into the grill tray up to the "MAX" Mark.
Note: Pour in the water until it covers the reflective metal sheet (7). The water
bath and the metal sheet prevent excessive heat radiation in the area of the
standing surface of the grill.
Therefore you should always grill food using water and with the reflective
metal sheet in place.
Before using for the first time, fill the grill tray with water and use it for 15 minutes to
remove the protective film from the heating coil. Select the MAX thermostat positi-
on. The presence of smoke is normal. Make sure that a sufficient level of ventilation
is available.
Preheat the device before use for approximately 5 minutes.
•
Insert the plug in a duly installed 230V/50Hz protective contact socket.
•
Fill in 1.5 l of cold water up to the "MAX" mark in the trough.
•
Set the thermostat for the desired use: a low or medium temperature for war-
ming or cooking, MAX. for rapid cooking and grilling. The LED shuts off when
the desired temperature is reached.
•
Lay the food directly on the grill grid. Never use plates, trays or aluminum foil
beneath the food. The grilling time depends on the thickness of the food and the
set temperature. Thick foods are grilled more quickly by piercing it with metal
skewers. Turn the food from time to time.
•
The height of the grill grid can be varied. Please see illustration 2.
•
Should the water level drop below the MIN mark after continuous use, pull the
plug from the socket and fill with water until the MAX mark is reached. Do not
pour any cold water over the hot heating element. Otherwise this may be dama-
ged.
18.12.2003 11:45 Uhr
Preliminary Operations
Usage
Seite 33
5
Grill grid
6
Handle
7
Reflective metal sheet
8
Stand
GB
33
Publicité
Table des Matières
