Safety Tips; Introduction; Pack Contents; Operation - Buffalo L413 Mode D'emploi

UK

Safety Tips

• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• Plates become hot during operation - DO NOT TOUCH!
• Always switch off and disconnect the power supply to the appliance when not in use.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of
local authorities.
• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified
technician in order to avoid a hazard.
• BUFFALO recommend that this product is connected to a circuit protected by an appropriate RCD
(Residual Current Device).

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.

Pack Contents

The following is included:
• BUFFALO Coffee Jug Hotplate
• Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Operation

The two hotplates work independently of each other. To use:
Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
1.
thoroughly removed from all surfaces.
Connect the appliance to the mains power supply.
2.
Place the coffee jug(s) on the hotplate(s).
3.
Turn the relevant power switch to the On position [I].
4.
WARNING: DO NOT allow the coffee jug to dry out. Damage to the jug may occur.
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
1