Kenwood KDC-3025 Mode D'emploi page 28

Troubleshooting Guide
?
Track Search can't be done.
For the discs first or last song.
For each disc, Track Search can't be done in
the backward direction for the first song or in
the forward direction for the last song.
If the following situations, consult your
nearest service center:
Even though the disc changer is connected,
the Disc Changer source is not ON, with "AUX1"
showing in the display during the Changer Mode.
The messages shown below display your
systems condition.
EJECT: No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
NO DISC: No disc has been loaded in the disc
magazine.
Load a disc into the disc magazine.
TOC ER: No disc has been loaded in the disc
magazine.
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
Clean the CD and load it correctly.
E-05: The CD is upside-down.
Load the CD correctly.
BLANK: Nothing has been recorded on the MD.
NO TRACK: No tracks are recorded on the MD,
although it has a title.
E-15: Media was played that doesn't have data
recorded that the unit can play.
Use media that has data recorded that
the unit can play.
NO PANEL: The faceplate of the slave unit being
connected to this unit has been removed.
Replace it.
E-77: The unit is malfunctioning for some reason.
Press the reset button on the unit. If the
"E-77" code does not disappear, consult
your nearest service center.
28
|
English
MECHA ER: Something is wrong with the disc
magazine. Or the unit is malfunctioning for
some reason.
Check the disc magazine. And then
press the reset button on the unit. If the
"MECHA ER" code does not disappear,
consult your nearest service center.
HOLD ER: The protective circuit in the unit activates
when the temperature inside the
automatic disc changer exceeds 60°C
(140°F), stopping all operation.
Cool down the unit by opening
the windows or turning on the air
conditioner. As the temperature falls
below 60°C (140°F), the disc will start
playing again.
NO NAME: Attempted to display DNPS during the CD
play having no disc names preset.
LOAD: Discs are being exchanged in the Disc
changer.
NO ACCESS: After setting it in the Disc Changer, DNPP
was done without having it been played at
least 1 time.
IN (Blink): The CD player section is not operating
properly.
Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.