TECHNICAL DATA
Definition in according to EN 13240
Constructive system
Nominal thermal power in kW
Efficiency in %
Smoke outlet diameter in mm
Chimney height ≥ (m) - dimension (mm)
Depression by rating calorific value in Pa - wood
Hourly wood consumption in kg / h (wood with 20% humidity)
CO measured at 13% oxygen in %
Exhaust gas emission in g/s - wood
Exhaust gas temperature in °C - wood
Hearth opening size in mm (W x H)
Hearth size in mm (W x H x D)
Oven size in mm (W x H x D)
Type of grill
Height in mm
Width in mm
Depth in mm
Weight in kg
Fire prevention safety distances
m
riscaldabili (30 kcal/h x m
3
(*) The proposed value are indicative. The installation must, in any case, be sized and verified according to the general calculation method in UNI
EN13384-1 or by another method of proven efficiency.
(**) For those buildings in which the thermal insulation does not correspond to the instructions on heat protection, the heating volume of the
product is: favourable type of building (30 kcal/h x m
x m
).
3
With thermal insulation in accordance with the regulations regarding energy saving, the heated volume is greater. With temporary heating, in
the event of interruptions which last more than 8 hours, the heating capacity is reduced by about 25%.
The declared technical data have been achieved by burning beech wood class "A1" according to the requirement UNI EN ISO 17225-5 and wood
moisture content less than 20%. By burning a different kind of wood the efficiency of the product itself could change and some specific adjustments
on the appliance could be needed.
TECHNICAL DESCRIPTION
Definition: product according to EN 13240. The appliance works as an intermittent operating appliance.
The chimney stoves of La Nordica are suitable to heat living spaces for some periods or to support an insufficient centralized heating system.
They are ideal for holiday apartments and weekend houses or as an auxiliary heating system during the whole year. As fuel, it is possible to
use wood logs.
The appliance is made up of a series of cast-iron elements joined to one another by a fixed joint, while the seal is assured by refractory putty.
The assembly is supported by tie rods and nuts located outside the heating body.
The devices are equipped with an integrated air circuit for the recovery of the heat made up of deflectors (radiant fins) on all external surfaces
of the heating body.
The devices are equipped with a hearth with double thickness rear part made up of a drilled extractible plate.
Through these holes, pre-heated air gets into the hearth; in this way, it is possible to achieve a post-combustion with an increase of the yield
and a reduction of emissions of unburnt gases.
The fireplace is equipped with a sight door with ceramic glass (resistant up to 700°C). This allows a charming sight on burning flames. Moreover,
in this way, any possible leak of sparks and smoke is avoided.
Room heating takes place:
a)
By irradiation: through the panoramic glass and the external hot surfaces of the stove, the heat is radiated into the environment;
b)
By natural convection: the passage of air through the coating and the covering hood releases heat in the
c)
By forced convection: a ventilation kit suitable to improve the distribution of heat by ventilation only either of the installation room
or of the adjacent local.
WANDA EVO
WANDA CLASSIC EVO
)
3
); less favourable type of building (40 kcal/h x m
3
ACCESSORIES
10 ( 1,0 mm H
0,08 - 936 mg/m
POKER
SERIES
SERIES
ENGLISH
WANDA
WANDA Classic EVO
EVO
1
8,5
85,1
160
(*) 4 - 250x250 Ø250
O)
2
2,3
0,08 - 936 mg/m
3
6,1
235
380 x 255
350 x 280 x 285
-
Movable - flat
1338
716
532
216
Chapter FIRE SAFETY
243 (**)
); unfavourable type of building (50 kcal/h
3
room.
GLOVE
SERIES
SERIES
1
8,5
85,1
160
10 ( 1,0 mm H
O)
2
2,3
3
6,1
235
380 x 255
350 x 280 x 285
-
1270
804
530
228
243 (**)
25