Installation - Ecler UMA Série Notice D'utilisation

9. INSTALLATION

The UMA series has been designed to offer the greatest possible flexibility and easiness
concerning installation and transport.
Each model of the range has milled lateral handles and an additional handle on the
backside which are helpful during the installation of the speakers.
In the following we explain the possibilities of installation for each of the speakers from the
UMA series.
UMA112
Includes 12 embedded nuts with M8 thread that allow to hang-up the speaker inserting
hooks, to which chains or steel cables can be attached. Also offers a standard 35mm pole socket for
mounting on ECLER TRIP01 tripod, ECLER SR12 wall anchor or ECLER POLE01 accessory for
fast configuration to the UMA SB118 subwoofer unit. (see included diagram)
UMA115
Includes 12 embedded nuts with M8 thread that allow to hang-up the speaker inserting
hooks, to which chains or steel cables can be attached. Also offers a standard 35mm pole socket for
mounting on ECLER TRIP01 tripod.
UMA215
Includes 3 hang-up points (two on the sides and one on the back) to insert the metallic
pieces from the accessory kit ECLER FL200 (see included diagram).
UMA SB118
The UMA SB118 subwoofer has been designed to be installed on horizontal surfaces.
Includes pole socket for inserting 35 mm shank of ECLER POLE01. This unit is also prepared to
stack other UMA SB118 or UMA112 / UMA115 units, due to milling on the upper side.
IMPORTANT NOTE
In no case should these equipments be suspended via their carrying handles; use
the accessories adapted to each application. Whenever loudspeakers are wall or ceiling
mounted, a redundant mounting system is obligatory as safety measure. Use a steel cable or
chain of suitable gauge to avoid the fall of the loudspeaker in case some element of the main
suspension system would break away from its fastening device.
7