IARP SUN 42.3 Instructions D'emploi Et D'entretien page 16

LOADING
Warning!
It's absolutely forbidden to place the product in the tanks over the max load level.
It is fundamental not to exceed the load limits indicated to avoid altering correct air circulation and
thereby avoid a higher product temperature.
WARNING! THE APPLIANCE IS INTENDED FOR THE SOLE STORAGE
OF PRE-PACKAGED PRODUCTS.
OUTER CLEANING
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry
with soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
Periodically remove from the static condenser the impurity (dust
and deposit) which obstruct a good circulation of the air.
A dirty condenser influences in a negative way the performance of
the equipment, increasing the energy consumption.
Cleaning should be carried out with a soft brush or preferably with
a vacuum cleaner.
The manufacturer recommends that this operation be
carried out only by an Authorized Technician.
-16-