IARP SUN 42.3 Instructions D'emploi Et D'entretien page 13

HANDLING
The unit is shipped anchored onto a wooden base and
protected by corner posts, cardboard top and nylon
wrapping.
It must only be handled using a fork lift truck with adequate
power to the load.
Positioning the appliance horizontally or on its side or
upside down is to be strictly avoided.
The equipment MUST be kept vertical.
SELECTING THE PLACE OF INSTALLATION
In selecting the place of installation, ensure that the following instructions are observed, this being
vital for proper and troublefree working of the cabinet:
• Do not install the cabinet outdoors.
• Do not install the cabinet in the vicinity of heating radiators or other heat sources.
• Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
• Do not install the cabinet where it is exposed to drafts from ventilators open doors.
• Pay attention to air outlet from air conditioners/ ventilators.
• Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons and other obstacles.
• It is necessary taht the condensing unit obtains a good circulation of air around it; also the area
around the condensing unit should not be obstructed by boxes or other objects; keep a distance
from the wall of 10 cm. at least.
Air-Condition
-13-