Genesis GBS900 Manuel D'utilisation page 6

SPECiFiC SAFETY rULES FOr BAnD SAWS
WArning:
(gAinED FrOM rEPEATED USE) rEPLACE STriCT ADHErEnCE TO
PrODUCT SAFETY rULES. if you use this tool unsafely or incorrectly, you can
suffer serious personal injury!
• Make sure saw is on a firm, level surface and properly secured
avoid injury from unexpected movement. Firmly clamp or bolt the saw to a support surface to
prevent slipping or sliding during the operation.
Unplug the saw before making adjustments, repairs, maintenance
•
or storing.
• Always switch off saw before unplugging it
replugging the saw into a power source.
• Use only the correct size and style of blade.
• Allow the motor to come up to full speed
binding or stalling.
• Wear eye protection. Do not wear gloves, necktie, or loose
clothing.
• Before making a cut, be sure all adjustments are secure.
• Use extra caution
• Small pieces should be secured with clamps or fixtures.
hold small pieces to prevent accidental contact with the blade.
• Make sure the blade teeth point down and toward the table.
• Keep hands out of saw blade line during the operation.
• Keep blade clean, sharp, and with sufficient set.
• Never cut more than one piece at a time
on the saw table at a time.
• Do not remove jammed material until the saw blade have stopped.
• Never start the saw
• Hold work piece firmly against the saw table during the cutting.
• Maintain proper adjustment of blade tension, blade alignment,
blade guides and thrust bearing.
• To avoid accidental blade contact,
maximum blade support, always adjust the blade guide assembly to just clear the work piece.
• Do not leave the work area until all moving parts have stopped.
unplug the saw and remove the switch key and store it in a safe place
• Do not operate with the cover door open.
• Do not operate in rain or in damp conditions.
SAVE THESE INSTRUCTIONS
9" Band Saw
Operator's Manual
DO nOT LET COMFOrT Or FAMiLiAriTY WiTH PrODUCT
with very large, very small or awkward work pieces.
when the blade is in contact with the work piece.
to avoid accidental starting when
before making the cut to avoid
or stack more than one work piece
minimize blade breakage, and provide
.
GBS900
to
Do not hand-