Remote Control; Dry-Run Protection; Automatic Preliminary And Fi Nal Fl Ushing - HOESCH Whirlsystem Deluxe Instructions De Montage Et D'utilisation

09.02 Remote control

⚠
Please read the separate WHIRL COMMANDER instruction manual before commissioning.
10

Dry-run protection

Hoesch Deluxe bathtub with whirlpool system is equipped with "dry run" protection. The whirlpool pump and the lighting
can be started only when the green LED diode is on. The "dry run" protection protects the system against start up when
the bathtub is empty or the water level is too low.
GB
11 Automatic preliminary and fi nal fl ushing
Preprogrammed rinsing programmes guarantee that all whirlpool bathtub components are rinsed both before and after
the bathing. Pre-rinsing (Airsystem, Whirlsystem i Whirl- +Airsystem) stars automatically when the bathtub is fi lling. It
takes about 5 minutes and uses from 10 to 13 litres of water depends on the bathtub model. Finishing rinsing (Airsystem,
Whirlsystem i Whirl- +Airsystem) starts automatically when the bathtub is empting. It takes about 10 minutes and uses
from 18 to 22 litres of water depends on the bathtub model. The rinsing process is signalled by a red LED diode on the
disinfection tank and LED diode on the top of the control panel.
It is not possible to interrupt the procedure! With reference to the two different whirl systems this means:
Air system:
Pre-rinsing: with fresh water which is directed to the outfl ow by air ducts
Finishing rinsing: with water from water supply system, disinfection liquid and fi nal drying by the blower.
Whirlsystem, Whirl- +Airsystem:
Pre-rinsing: the water inside massage jets, pipes and the whirlpool pump and circulates with fresh water and disinfection
liquid.
The end of the fl ushing procedure is indicated by the red LED on the disinfectant reservoir or the top LED on the keypad
going out.
34
Minimum height of water level
LED red / flushing
Minimum height
of water level
Control panel