Fracarro SIG7710 Instructions D'emploi page 40

7. Enter the MULTICAST menu to define and set all parameters relevant to the MULTICAST groups.
After setting the parameters, confirm them with the SAVE control.
From this menu, the following options can be selected:
Multicast IP --> IP Multicast address settings;
Multicast Port --> setting the port to be used for Multicasting, WARNING: if the RTP option is enabled
port Multicast can only assume equal value between 104 and 65535. If RTP is disabled if the port
Multicast can take any value between 104 and 65535.
RTP Layer --> enabling/disabling the Real Time Protocol used in the distribution of the Audio/Video
contents on IP (disable for default);
Enable --> Enabling/disabling the Multicast group;
WARNING: the IP addresses selected for multicasting must be chosen within the 4.0.1.1 -->
39.55.55.55 range. To set addresses and Multicast ports correctly, see the RFC regulations and
the network administrator where the SIG7710 module will be inserted.
8. Re-enter the PROGRAM LIST menu to "send" the video/audio program to the chosen multicast
group according to the following indications:
a. To activate the program in Multicasting transmission, select the "send" control (the program status
will turn from "send" into "stop" and the bit/rate associated to the program will change from 0Kbit/s
to the typical bit/rate value associated to the program – see the following image):
40