The SIG7710 module can be restored to the original factory settings (default parameters). To set
these parameters, refer to the TPE GENERAL MENU (HEADEND SETUP --> FACTORY SETUP -->
SIG7710).
5.2 INITIAL PROGRAMMING THROUGH THE TPE
Connect the universal TPE programmer to the interconnection module of the sub-rack. The TPE
1.
switches on automatically,
.
carries out the headend scanning,
3.
the modules contained in the headend are recognized automatically.
Continue with the headend navigation and select the position occupied by the SIG7710 module (refer
to the HEADEND SETUP AND KTP EMULATION MENU).
NOTE: the menu language can be changed. To modify this setting, refer to the GENERAL MENU
OF THE TPE (TPE SETUP --> LANGUAGE). It is essential to verify that the set timeout is equal to
30. To verify this setting, refer to the TPE GENERAL MENU (TPE SETUP --> TIMEOUT COM).
IMPORTANT: Press the
within 5 minutes from the last modification, the set data will be lost and the previous data will be
restored.
TPE keys
......
Graphic indications of
the menu diagrams
5.1 DEFAULT PARAMETERS
key of the TPE to save the set parameters. If the key is not pressed
To confirm an entered value or to select a menu
To cancel an entered value or exit a menu
To scroll through menu items
To save the modifications
Select the menu by using
Scroll the menu to the right
Scroll the menu upwards
Scroll the value to the right
9
Key Function
To enter values
Meaning
or
keys and exit with the
or to the left
or downwards
or to the left
key