Télécharger Imprimer la page

Vorbereitung Des Mähwerkes Für Arbeits- Und Transportstellung; Preparing The Mower For Work And Transport Position - SIP OPTICUT DISC 220 F ALP Mode D'emploi

Publicité

4.
Vorbereitung des Mähwerkes
für
Transportstellung
Bei Vorbereitung der Maschine für
Transport-
unbedingt die Gelenkwelle ausschalten.
Motor abstellen und Zündschlüssel
abziehen.
Traktor
sichern!
Beim
Befahren
Strassen darauf achten, dass Sie den
vorgeschriebenen Schutz benutzen.
Bild - Figure 25
1
Mähwerk in Transportstellung:
Stellen Sie den Schutz (1) auf der linken
und rechten Seite in die Transportstellung
um.
Heben
Sie
das
Transportstellung auf.
Stellen Sie das Mähwerk in die Mitte.
Mähwerk von Transport- zur Arbeitsstellung:
Fahren
Sie
Arbeitsstellung.
Stellen Sie den Schutz (1) auf der linken
und rechten Seite in die Arbeitsstellung um.
108
Arbeits-
und
und
Arbeitsstellung
gegen
Wegrollen
von
öffentlichen
1
Mähwerk
in
das
Mähwerk
in
4.
Preparing the mower for work
and transport position
When
transport and work position always
switch off the P.T.O.shaft. Switch off the
engine and pull out the ignition key.
Secure tractor against movements.
When driving on public roads use the
protections according to regulations.
The mower in transport position:
Change the covers (1) on the left and right
hand side over to the transport position.
Lift the cutter bar into the transport position.
die
Place the cutter bar into the centre.
The mower from transport to work position:
die
Lower the cutter bar to the working position.
Change the covers (1) on the left and right
side over to the working position.
preparing
the
machine
Bild - Figure 26
for

Publicité

loading