TDK-Lambda EFE300 Mode D'emploi page 13

EFE300 Handbook
Special Instructions for IEC/EN/UL/CSA 61010-1
If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment
may be impaired.
DC input does not apply to 61010-1.
Environmental Specifications:
Description
Use
Temperature
Humidity
Altitude
Pressure
Orientation
Material Group
Pollution Degree
Overvoltage Category
Class
Weight
IP Rating
Note: fan models require a 40mm minimum gap at the input and output ends.
Level of Insulation:
Dielectric Strength testing is carried out as follows:
Primary mains circuit to earth - 2.25 - 2.35Kvdc.
*Primary mains circuits to secondary: 4.25-4.35kVDC.
Outputs to earth are isolated to 200VDC.
*Important Note: This test is not possible with Y capacitors fitted to the unit as damage to these capacitors may occur.
It is also necessary to short circuit the outputs together and to earth.
Safety Approvals:
UL60950-1 and CSA22.2 No.60950-1 - UL Recognised. C-UL for Canada.
UL61010-1 and CSA22.2 No.61010-1 - UL Recognised. C-UL for Canada.
IEC / EN60950-1 - CE mark.
IEC/EN61010-1 and IEC/EN60950-1 - CB Report and Certificate
CE marking when applied to any EFE300 product indicates compliance with the Low Voltage Directive in that it
complies with EN60950-1 and with the ROHS Directive.
Fusing
Internal fuses (F1): dual fuses in the L and N line (except single fuse in the live line for the L option), F8AH, 250V,
5x20mm
Symbols:
AC DC
Operation
Indoor
0
0 to 70 C(derating 2.5% above 50°C)
5 to 95% RH, non-condensing
-200m to 3000m
78kPa to 106kPa
Customer air models:
Horizontal cover uppermost, PSU on
either side, Vertical
EARTH
Page 13 of 20
5 to 95% RH, non-condensing
Horizontal cover uppermost, PSU on
either side, Vertical with input lowest
IIIb
2
II
I
1 Kg max
IPX0
N – Neutral
Storage
-
0 0
-40 C to +70 C
-200m to 5000m
54kPa to 106kPa
Fan models:
L – Live
17358 issue 14, October 2018