Clatronic HL 2266 Mode D'emploi & Garantie page 27

4....-05-HL 2266 neu
1. If you would like to operate the fan heater in an upright position, please place it
on the second additional foot supplied.
2. After assembling the iron support fix the screws into the equipment. Please
make sure that the iron bars are placed between the stand (foot) and the
thread.
3. After assembling connect the device to a duly installed 230V/50Hz socket with
earthing protection!
4. Make sure that the degree of protection of the socket to which the device is
connected is of at least 10 ampere!
5. The device can either be placed on a suitable flat surface or mounted on the
wall with the wall hook (see drawing). In case of wall mounting make sure that
the air can freely enter and exit from the device.
6. In order to use the device as a standing unit, mount the base as illustrated
in fig. 1.
7. If the base is attached to the wall with the enclosed screws, then it can be used
as a wall clamp (see fig. 2 and 3).
= OFF
= Hot air (1000 W)
1 Lowest level
Turn the thermostat control knob to the highest level. The LED will light up.
Once the desired room temperature is reached, turn the thermostat control knob
slowly back until the device shuts off.
The thermostat maintains the set room temperature by switching the device on and
off.
The device is equipped with an overheating protection that switches the device
automatically off in case of overheating. Shift the function switch to „0" position and
pull out plug out of the socket. Let the device cool down for about 10 minutes before
using it again.
Should the overheating protection shut the device off again shortly after, there is
probably a defect. Switch off the device again and pull out the plug. Let the device
be checked by an authorized dealer or by our customer service (or contact your
dealer).
24.05.2002 9:43 Uhr
Operation
Function Switch (Fig. 4)
Thermostat (Fig. 5)
2 Highest level
Overheating Protection
Seite 27
= Cold air
= Hot air (2000 W)
GB
27