Sony PCS-UC500 Mode D'emploi page 15

To remove the card
Press the 6 memory card eject
button on the front of the
Rollabout Processor.
6
Note
When the BUSY lamp on the front of
the Rollabout Processor is on, do not
press the 6 memory card eject button.
Since it may destroy the data on the
card.
4
Select [OTHER] from MAIN
MENU.
The sub-menu appears.
P in P MULTI INPUT
QUICK GRAPH
DIAL MENU
5
Select [SETUP].
The SETUP menu appears.
OBJECT CAM ON
SETUP
VID CONTROL OFF
AUX 1 ON
SUB CAM CONTROL ON
AUX 2 ON
RGB ON
SCANNER ScanJet
PRINTER A4
DUAL MONITOR OFF
T.120 AUTO
BRI RATE AUTO
V.35/X.21 PORT DUAL
UPGRADE
SETUP
STATUS
USER DATA
DIAL
CAMERA POINT AUDIO OTHER
END OF
MEETING
[OTHER]
FORMAT MEMORY CARD
CAM BRIGHT
CAM CONTROLED ON
LIP SYNCH AUTO
SIRCS OUTPUT 2
GRAPHIC JPEG
LANGUAGE ENGLISH
ANSWER MODE AUTO
LDN
EXIT
6
Select [UPGRADE]
The status is indicated on the
screen.
PCS-UC500
PCS-UC400
PCS-UC410
OFF: The Upgrade Card has not
been installed yet.
ON: The Upgrade Card has
already been installed.
If you only want to check the
installation status of the card,
select [EXIT] to go back to the
SETUP menu.
If the [UPGRADE] icon is
dimmed
Turn off the Rollabout Processor
power once, then press the
POWER ON switch with the card
in.
After about one minute, MAIN
MENU appears. Repeat the same
procedures from step 4.
7
Select [UPGRADE] when you
want to install the card.
Installation begins.
When installation is complete, the
indication changes from [OFF] to
[ON].
OFF/ON
OFF/ON
OFF/ON
UPGRADE EXIT
(Continued)
15