Publicité
Les langues disponibles
Les langues disponibles
• Immediately disconnect the external adaptor from the power source if you detect any of the following:
4. When charging is complete, disconnect the external adaptor from the power source and unplug the
charging cable from the unit and external adaptor.
Normally the robot can operate up to 45 minutes on a full charge.
NOTE: Clean the debris compartment regularly. Excessive debris inside the debris compartment increases the burden to the
motor operation and shortens the operating duration as a result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a limited life and will gradually lose its
capacity to hold a charge. Therefore, the running time of the robot will gradually reduce after repeated charging and
discharging throughout its product life.
Once the lifespan of the battery reaches its end, refer to section "BATTERY DISPOSAL" for instructions regarding battery
disposal and replacement of swivel head.
NOTE: Let the robot rest for around 30 to 40 minutes before charging it again.
Set- up Before Use
Adjustment of Trajectory
Locking Pin
The trajectory of the robot is dependent on the position of the pin that fixes the axle to a certain angle. Alter only the position
of the pin on left.
Recommended settings:
NOTE: Wheel axle should be positioned above the locking pin.
1
2
5
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
1
2
Pin location
Pool size
For pools where the shortest
length is 2 meters or above.
(Factory setting)
For pools where the shortest
length is 2 meters or below.
Publicité
