Kokido RC16 Manuel D'utilisation page 13

TROUBLESHOOTING
Problem Possible Cause
Robot does not start Stained water sensors
working under water
Robot does not Battery is running out
capture the debris Impeller is jammed
Suction mouth is clogged
Impeller is broken
Debris compartment is full
Robot stopped Robot stopped by obstacle or large
moving in the middle creases in the pool liner
of pool but swivel Robot is hindered by suction from
head is still turning the main drain of pool floor
Swivel head rotates Air trapped inside the robot
repeatedly
Robot does not Debris compartment is full
cover the entire Operation time is shorter as expected
pool Moving direction is interrupted by
water circulation generated by
filtration system
Wheel is jammed
Position of locking pin is not set properly
Algae renders the pool floor slippery
which results in the robot going in circles
Robot moves along Position of locking pin is not set
the pool wall properly / robot facing direction is
wrong at beginning
Robot moves slowly Debris compartment is full or filter
or does not move cover is clogged
at all
Suction mouth is clogged
Impeller is jammed
Swivel head does Side flap does not come up
not turn or turn
noticeably slowly Swivel head bottom is jammed
Solution
Use a cotton bud soaked with juice of lemon or vinegar to
clean and remove the stains.
Charge the robot again.
Power off the robot and inspect the hole under the swivel
head to see if the impeller is jammed by large debris.
If necessary, contact your dealer for further instructions.
WARNING! Make sure the robot is off before
the unit is serviced.
Remove clogged objects from the suction mouth.
Contact your dealer for replacement.
Clean both debris compartment and filter cover.
Check to see that if there is anything obstructing the cleaner.
Remove the obstacle.
Turn off the filtration system as instructed in manual.
Submerge the robot while it is still off in the pool and gently
shake it a few times to facilitate discharge of air before
switching it on (while robot is still submerged).
The swivel head may rotate repeatedly for a short while
once the robot sinks to the pool bottom. This phenomenon
will stop once the air trapped inside the robot is discharged
and the robot will begin to move regularly.
Clean the debris compartment.
Clean the filter compartment and recharge the robot for 6 hrs.
Turn off the filtration system (as instructed in filtration
manual) at least 15 minutes before robot operation.
Check and remove debris from the wheel.
Follow instruction to adjust the locking pin position.
Scrub the pool bottom and robot wheels to remove the algae.
Follow instructions to adjust locking pin setting. Make sure
that robot's front/back faces the pool wall at beginning.
Clean the debris compartment. Flush the screen with water
to remove small particles. If brushing is deemed necessary,
use a soft brush to clean the screen gently. Note: make
sure that the filter cover is in place before next operation.
Remove clogged objects from the suction mouth.
Power off the robot and inspect the hole under the swivel
head to see if the impeller is jammed by large debris.
If necessary, contact your dealer for further instructions.
WARNING! Make sure the robot is off before
the unit is serviced.
Check and remove any debris that hinders the movement of
the flap.
Detach the swivel head and smoothening-ring in accordance
with instructions of section "How to remove the battery
pack" from the manual, then:
- Remove trapped debris.
- Inspect the smoothening-ring for potential damages and
wear and tear. Replace with a new one if necessary.
- Verify the smoothening-ring and bottom plate are installed
correctly. (refer to below diagrams)
12