Télécharger Imprimer la page

Kokido RC16 Manuel D'utilisation page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
Problem
Debris escapes
from the robot
Debris leaks outside
at the filter cover
Round float sinks
Retrieval cord is kinked
Duration of cleaning
cycle is shorter than
advertised
Robot cannot be
charged / recharged
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly recycles
electrical and electronic equipment. Do not dispose them in unsorted waste bins. For items containing removable
batteries, remove batteries before disposing of the product.
© 2020 Kokido Development Ltd.
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of
Kokido Development Ltd. (V1)
If soft copy of this instruction manual is required, please contact our customer service by email:
customerservice@kokido.com
Manufacturer: Kokido Development Limited. Unit 1319, Sunbeam Centre, 27 Shing Yip Street, Kwun Tong, Kowloon, HK
13
Possible Cause
Suction mouth's flap (at cleaner
bottom) is damaged
Debris clogged at suction mouth and
prevents the flap to close
Filter cover net is damaged
Damaged float and water leakage
Retrieval cord length is too long
Battery is not fully charged
Battery is damaged
Charging cable is not completely
connected with external adaptor
and robot
External adaptor is out of order
SAVE THESE INSTRUCTIONS
Solution
Suction mouth's flap works like a door to prevent the debris
from escaping from the debris compartment. Contact dealer
for replacement parts and instruction.
Remove clogged debris from the suction mouth.
Replace with a new filter cover from your dealer.
Replace with a new float from your dealer.
Adjust the length according to instructions in the manual
Charge the robot for at least 6 hrs. NOTE: if any stains are
found on the charging pins, remove them by using a cotton
bud soaked with lemon juice or vinegar.
Contact dealer for battery replacement.
WARNING! DO NOT replace the battery by
yourself. This could result in severe or fatal
injuries and the warranty will be voided as a result.
Make sure that the charging cable is connected with
external adaptor and robot properly and completely.
Refer to instruction manual.
Contact dealer for replacement.
WARNING! Using the wrong external adaptor
will result in damaging the robot / battery and
voiding the warranty as a result.
Made in China
20009011

Publicité

loading