Absaar HF-1202 Instructions D'utilisation page 10

10
FEATURES
1.
Charging indicator - yellow LED, when battery is charging the yellow LED is lit.
2.
Full charge indicator - green LED, when the battery is fully charged or the charger switches into float charge
mode, the LED is lit; and when there is no load in the circuit, it also illuminates.
3.
Reverse polarity indicator - red LED, when battery clips are wrongly connected to the battery the LED is lit
4.
DC cable - DC output cable with red (+) and black (-) clamps for connection to the battery.
5.
Ventilation openings - be sure the ventilation openings are free from obstruction.
6.
Power cable - connect to a standard 230V AC power outlet.
Note:
the 2A battery charger is the correct charger for battery capacities up to 30Ah, it is also a good mainte-
nance charger for batteries with a capacity of up to 30Ah.
OPERATION INSTRUCTIONS
· Ensure the battery charger is disconnected from the power supply.
· Connect the red charger clamp to the positive terminal of the battery (+) symbol.
· Connect the black charger clamp to the negative terminal of the battery (-) symbol.
· Plug the charger into the AC mains power. The yellow LED will light up showing that the
battery is charging.
CAUTION: If the yellow charging light turns off and the red light turns on, immediately
disconnect from the AC mains power, check the polarity of the battery clips to the battery
terminals.
· When fully charged, the green LED light turns on. The recharge time will vary based on
the capacity and discharge state of the battery.
· Disconnect the power supply cable from the standard AC outlet.
· Disconnect the black charge clamp from the negative terminal of the battery (-) symbol.
· Disconnect the red charge clamp from the positive terminal of the battery (+) symbol.
· Store the battery charger in a dry place.