STERWINS 900 WT 24-4 Notice De Montage, D'utilisation Et D'entretien page 215

8.4 TROUBLESHOOTING
serious injury. Warning ! Before any trouble shooting, switch
Problems
There is no electric current
The Pump fails to
Start up
Suction hose is not in water
Air in the suction hose
Pump does not
suck water
Check valve dirty or leaks
Strainer dirty or blocked
Suction height too high
Water level falling rapidly
Inadequate
Hose diameter and/or hose
delivery rate
length are not suitable with
The discharge head is too
high or there are too many
Probable causes
Pump shaft blocked.
water
Max. suction height
exceeded
Suction kit is dirty
Pre Filter is dirty
the installation
connected devices
215
Solutions
Ensure that the electric current
is on
Use a screwdriver to turn the
motor fan
bolt slightly
Immerse suction hose in water
Fill with water (as explained on
the chapter priming the pump)
Make sure the suction hose is
well sealed
Clean or replace the check valve
Clean the strainer
Check suction height
Check suction height
Clean the suction kit
Immerse intake valve deeper
and make
sure intake line well sealed.
Use a larger hose diameter or a
shorter hose length
Adjust the discharge head
and the connected devices
regarding the capacity of the
pump (please refer to technical
datasheet)
FR
ES
PT
IT
required
EL
-
PL
RU
KZ
-
UA
RO
EN
-