Pfaff HX 150 Mode D'emploi page 9

Scissors-lift trolleys
English
Operating Instructions
RAISING
Type HX 150; HX 300; HX 500;
HX 750; HX D 350
The scissors lift truck is
equipped with a hydraulic
pump. Use the foot pedal to
raise the load.
.
Handling:
Check the following before you start work:
The operator controls work properly
The roller brake works properly
The rollers and roller axles are in good condition
Check for leaks
Check setting, tension and wear of the lifting chains.
Picking up the load
Make shure the load does not exceed the carrying capacity of the scissors lift truck
The load must be evenly distributed
across the platform
Moving with a load
Do not use the scissors lift truck on a sloping surface.
When you transport the load, raise it as little as possible off the ground (max. 100 mm), but watch the clearance
below the load.
Watch out for obstacles in the path of the truck!
When you stop the truck, be sure to apply the roller brake.
Be sure that the load is lowered before you move the truck.
Roller Brake
A brake is mounted on the steering rollers of the scissors lift truck.
Be sure that the brake is applied and locked when you stop the lift truck.
Subject to change without notice
Type HX 150
Lift up the
lowering lever.
Pressing the
lever further
increases the
lowering speed.
F06.08.031
LOWERING
Type HX 300; HX 500; HX 750; HX D 350
Turn the lowering valve
counterclockwise. Turning
the valve further
increases the lowering
speed. The operator must
adjust the lowering speed
to meet requirements.
loosening
locking
page 9