Kompernass WK 8 A2 Mode D'emploi page 70

Time lapse video resolution
Select the time lapse video resolution: 2592 × 1944P or 2048 ×
1536P. The higher the resolution, the more detailed the recordings.
At higher resolutions, the capacity of the memory card is exhausted
faster. This setting only applies to time lapse recordings.
Video length
Use the /
(between 3–59 seconds or 1–10 minutes) that will be made when
video recording is activated. The longer the recording time selected,
the shorter the operating time. The preset video length is 5 seconds.
Audio recording
If you want the camera to record sound when recording videos,
select "On" here.
Shot lag
Use the /
camera should wait before reacting to subsequent activation of the
main sensor after the initial recording. During the selected interval,
the camera will not record any images or videos. This prevents the
memory card from being filled up with too many recordings of the
same event. You can select between 5–59 seconds or 1–60 minutes.
Side motion sensors
The two side motion sensors
If the side motion sensors are being affected by branches blowing
in the wind, for example, select "Off", confirm with the OK button to
deactivate the side motion sensors. Otherwise the moving branches
will trigger recordings. The default setting is "On".
│ GB │ IE
■ 66
buttons to select the length of the video recording
buttons to select the minimum time period that the
6
can be switched on or off here.
WK 8 A2