AEG FAVORIT 66602 IM0P Notice D'utilisation page 32

32 www.aeg.com
• The indicator
flash.
• The display shows the current
setting: e.g.
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
and the display is blank.
2. Press Delay.
• The indicators
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid are
– Level 0 = no rinse aid is
3. Press Delay again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
continues to
= level 5.
and start to flash
and
go off.
continues to
= level 4.
from 0A to 6A.
released.
6.4 Use of rinse aid and multi-
tablets
The factory setting of the rinse aid
dispenser is with the dispenser activated.
This means that the rinse aid dispenser
always releases rinse aid.
It is possible to deactivate the rinse aid
dispenser, in this case the dispenser will
not release rinse aid only if the option
Multitab is activated.
If the dispenser is deactivated and you
do not select the option Multitab, the
dispenser will release rinse aid.
The use of the option Multitab with the
rinse aid dispenser deactivated may not
give satisfying drying results.
When the rinse aid dispenser is
deactivated, the rinse aid indicator is
always off when the option Multitab is
activated.
How to deactivate the rinse
aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
,
Option until the indicators
and the display is blank.
2. Press Start.
• The indicators
go off.
• The indicator
continues to flash.
• The display shows the current
setting:
dispenser is activated (factory
setting).
3. Press Start to change the setting.
= the rinse aid dispenser is
deactivated.
4. Press the on/off button to confirm
the setting.
and start to flash
and
= the rinse aid
,