Evolite M3000 Mode D'emploi page 11

Hazardous voltage. Risk of electric shock!
Use only Powercon power cable.
ALWAYS disconnect the fixture from power for servicing, for cleaning or installing.
Do not connect this unit on a dimmer power pack.
Protect the unit from rain or moisture.
WARNING!
Fire Hazard!
Keep flammable materials away from the fixture. Do not operate the fixture with ambient temperature over
40°C.
Do not place any filter on the head of the fixture. Keep any combustible materials away from the unit: At least
5 meters.
DANGER!
Safety Hazard. Risk of injury.
This evolite unit must be installed by professional people. If suspended, make sure the structure and the
hardware used for this suspension is secured. This Hardware must support at least 10 times the weight of the
device suspended. Ensure public is not looking at the beam. Do not try to repair the fixture by yourself. Contact
a professional repair service.
 Unpack and check carefully there is no transportation damage before using the fixture.
 It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
 LASER light can cause permanent eye injuries if eyes are exposed to the laser light.
 Disconnect main power before servicing and maintenance.
 Maximum ambient temperature is: 40℃. Don't operate it when the temperature is higher than this.
 In the event of serious operating problem, stop using the fixture immediately. Never try to repair the fixture
by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the
nearest authorized technical assistance center. There are no user serviceable parts inside the fixture except
the fuse.
 Do not connect the device to any dimmer pack.
 To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain or moisture.
 Do not look directly at the LASER light beam while the fixture is on.

Do not touch any wire during operation.
 The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching
the unit is secure and is able to support a weight of 10 times of the unit's weight. Also always use a safety
cable that can hold 12 times of the weight of the unit when installing the fixture.
 The equipment must be fixed by professionals. And it must be fixed at a place where is out of the touch of
people and has no one pass by or under it.
 Operating Premises: Whenever possible, the operation of a LASER should be done in a room or in an
enclosed or delimited place for this purpose.
 The access of room and openings to the outside must not be located in the axis of a direct beam.
 The floor must be free of obstacles. The causes of accidental reflection and scattering of laser beams must
M3000 User Manual Ver. 1.00 Page 11