Publicité
Les langues disponibles
Les langues disponibles
CAUTION! Make sure that when
you close the door, the laundry
does not catch between the
appliance door and the rubber
seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options for the
type of load.
The display shows the programme duration.
4. Press the Départ/Pause (Start/Pause)
touchpad.
The programme starts.
STARTING THE PROGRAMME WITH DELAY
START
1. Set the correct programme and options for the
type of load.
2. Press the delay start button again and again
until the display shows the delay time you want
to set.
You can delay the start of a
programme from a minimum of 60
minutes to a maximum of 20
hours.
3. Press the Départ/Pause (Start/Pause)
touchpad.
The display shows the countdown of the delay
start.
When the countdown is completed, the programme
starts.
CHANGE A PROGRAMME
1. Press the on/off button to deactivate appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
HINTS AND TIPS
PREPARING THE LAUNDRY
•
Close the zippers.
•
Close the fasteners of the duvet covers.
•
Do not keep ties or ribbons loose (e.g. apron
ribbons). Tie them before you start a
programme.
•
Remove all items from the pockets.
•
If an item has the internal layer made of cotton,
turn it inside out. Make sure that the cotton layer
is always external
•
We recommend that you set the correct
programme applicable for the type of fabrics
that are in the appliance.
STAND-BY FUNCTION
To decrease the energy consumption, this function
automatically deactivates the appliance:
•
After 5 minutes if you do not start the
programme.
•
After 5 minutes from the end of the programme.
AT THE END OF THE PROGRAMME
When the programme is completed:
•
An intermittent acoustic signal operates.
•
The indicator
flashes.
•
The indicators
plein (Tank) comes on.
•
The Départ/Pause (Start/Pause) indicator is on.
The appliance continues to operate with the crease
guard phase for approximately other 30 minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when the
phase is almost completed or completed.
When the crease guard phase is completed:
•
The indicator
is on but does not flash.
•
The indicators
plein (Tank) comes on.
•
Départ/Pause (Start/Pause) indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty the
water container when a programme is
completed.
•
Do not put fabrics with strong colours together
with fabrics with light colours. Strong colours
can bleed.
•
Use an applicable programme for cotton jersey
and knitwear to prevent the items to shrink.
•
Make sure that the laundry weight is not more
than the maximum weight that is in the
programme table.
•
Dry only the laundry that is applicable for tumble
dryer. Refer to the fabric label on the items.
Filtre (Filter) and
Bac
Filtre (Filter) and
Bac
59
Publicité
