Télécharger Imprimer la page

FLAEM Neb-aid Mode D'emploi page 7

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
- Remove the disinfected parts and rinse abundantly with warm potable water.
- Dispose of the solution following the instructions provided by the disinfectant
manufacturer.
method B: Sanitise the accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5-C6 by boiling
them in water for 10 minutes; use demineralised or distilled water to prevent calcium
deposits.
method C: Sanitise the accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5-C6 with a hot
steam steriliser for baby-bottle (not the microwave type). Perform the process faithfully
following the instructions of the steriliser. To ensure that the disinfection is effective,
choose a steriliser with an operating cycle of at least 6 minutes.
After having disinfected the accessories, shake them vigorously and place them on a
paper towel. Alternatively, dry them with a jet of hot air (for example, from a hair dryer).
At the end of each use store the device complete with accessories in a dry place away
from dust.
REPLACING THE FILTER
The device has a suction filter (A3) that should be replaced when it is dirty
or changes color. Do not wash or reuse the same filter. Regular replacement
of the filter is required to help and ensure correct performance of the
compressor. Check the filter on a regular basis. Contact your local dealer or
authorized service center for spare filters.
To replace the filter:
Insert a flathead screwdriver between the edge of the filter and the body.
Lift the filter and remove it by turning and pulling it. The filter has been
designed so that it is always fixed in its seat. Do not replace the filter
during use.
Only use original accessories and spare parts by Flaem, we disclaim
any liability in the event of using non original spare parts or accessories.
5

Publicité

loading