Operation; Main Unit Operation - Sharp FP-N60CX Manuel D'utilisation

OPERATION

MAIN UNIT OPERATION

The unit will start operating when the MODE-ON / OFF Button is pressed.
The unit will begin operating in the AUTO Mode. (fan level)
• While operating the Plasmacluster Indicator Light will be on.
To switch operating controls, press the MODE-ON / OFF Button until
the desired control is activated. (Your desired control will have its
Indicator Light lit.)
For the best results of the room environment, set your operation control as desired.
AUTO operation
The fan level is automatically
switched (HIGH, MEDIUM, SI-
LENT) depending on the
amount of impurities in the air.
The sensors detect the impu-
rities for efficient air purifica-
tion.
SILENT operation
The unit will operate quietly
using minimal air intake.
For the first 30 seconds after the power plug is in-
serted into the wall outlet, the unit will check the
condition of the air. If operation is set to ON during
this time, the CLEAN-SIGN LIGHT will alternately
flash green, orange and red.
Plasmacluster Indicator Light
Plasmacluster
MODE-ON / OFF Button
Stop
POLLEN mode operation
The unit will operate at High level for
10 minutes, then will alternate be-
tween MEDIUM and HIGH.
MEDIUM to MAX operation
The unit will operate at a fan level of
MEDIUM, HIGH or MAX.
E-14
Main Unit Controls
• AUTO
• SILENT
• MEDIUM
• HIGH
• MAX
• POLLEN
10 minutes: High fan level
20 minutes: Medium fan level
20 minutes: High fan level