Sharp FP-N60CX Manuel D'utilisation page 11

Pollen Mode Indicator
Light
MAX
POLLEN
h
SIGN
Remote Control Receiver
MODE-ON / OFF button
(Used to select operations or turn the unit off)
Sensor sensitivity select switch
The unit's sensitivity to odor and dust detection can be ad-
justed. This setting is factory set to "NORMAL", and it is rec-
ommended that you use the unit in this setting. Set the sen-
sitivity to "SENSITIVE" if the sensitivity seems too low de-
pending on the room condition.
Filter Reset Button
Odor Sensor
Detects odors such as tobacco smoke, pets, cosmetics, etc.
Sensor Cover
Dust Sensor
Detects dusts, smoke, pollen, house dust, etc. See Page E-18,E-20
Main Unit
Filter Frame
True HEPA Filter (white)
(Dust Collection Filter with Anti-Bacterial Apatite Filter sheet covering its front surface)
Washable Active Carbon Filter (black)
(Deodorizing Filter)See Page E-16
Filter Separator
Pre-Filter
Front Panel
Hook
Remote Control
See Page E-15
CLEAN-SIGN LIGHT
The color changes according to the air condition.
Clean (Green)
CLEAN-SIGN
ABOUT THE CLEAN-SIGN
• The sensors display a CLEAN-SIGN depending on relative changes
to the environment from the time the power plug is inserted into the
wall outlet and thereafter.
• When the air is extremely impure at the time the power plug is in-
serted, the CLEAN-SIGN LIGHT may light green since the impure
condition is the environment against which the sensors base the im-
purity rate on. In this case, operate the unit for a while in Clean Mode
first, then switch to the desired operation mode. See Page E-15
• To reset the base impurity rate on the CLEAN-SIGN remove and
insert the power plug.
• The CLEAN-SIGN LIGHT can be turned off using the "Display ON/
OFF" Button of the Remote Control. See Page E-15
See Page E-14
See Page E-19
Slightly Impure (Orange) Very Impure (Red)
CLEAN-SIGN
SENSOR
NORMAL
*Before pressing the Filter Reset But-
ton, be sure that the unit is plugged in.
There is also a Filter Reset Button on
the remote control.
After cleaning and reinserting the
Washable Active Carbon Filter, press
the Filter Reset Button.
E-9
CLEAN-SIGN
SENSITIVE
FILTER RESET