On/Off Switch - Toolland VL 110 Mode D'emploi

VL 110
Soft materials such as leaves or stems

may block the feeding opening. Feed the
soft material using a push bar (not
supplied).
Always feed the material to be chopped

from the right corner of the feeding
funnel.
Check the material to be chopped

carefully. Make sure that there are no
stones or nails present as these could
seriously damage the shredder.
Check for signs of vibration. Heavy

vibration is caused by damaged or worn
blades. Change the blades if necessary.

ON/OFF SWITCH

Press the green button to switch the

shredder on.
Press the red button to switch the

shredder off.
The machine is equipped with a safety

switch to prevent it from being switched
on again accidentally after a power
failure.
TROUBLESHOOTING
The motor does not run:
The overload protection has responded:

set the rotational direction switch on
position 0 and press the reset button,
keep the on/off switch pressed for a short
period to switch on the shredder. After
blocking has been removed reset the
rotational direction switch to the position
1.
Power failure: check the power supply

cable, the plug and the house fuse. The
material to be chopped is not drawn in.
The cutting blade is running backwards:

switch over the direction of rotation.
The material is jammed in the feeding

funnel: set the rotational direction switch
on position 0 and switch the shredder on.
Pull the material from the feeding funnel.
Re-feed thick branches such that the
blade does not immediately engage the
pre-cut notches again.
The cutting blade is blocked: set the

rotational direction switch on position 0
and switch the shredder on. The cutting
blade will now run backwards to release
the blocked up material.
www.toolland.eu
Allow the shredder to come to a complete

standstill before changing the direction of
rotation.
TECHNICAL DATE
Voltage
Frequency
Rated Power
Operating mode
No-load speed
Branch diameter
Weight
Sound power level
Sound pressure level
The S6 operation mode (40%) indicates a
load profile of 4 minutes load and 6 minutes
idle time. The maximum diameter of the
branch depends on the hardness of the wood.
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement after
exceeded use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
English
230V
50Hz
2500W
S6
40RPM
Max 40mm
26KG
91dB(A)
79dB(A)
21