Electrical Safety - Toolland VL 110 Mode D'emploi

VL 110
Never move the shredder by pulling the

cables.
Always disconnect the machine from the

mains supply before transporting it to
other places.
Always switch off the shredder before

disconnecting any plug and socket
connector or extension cables.
Never leave the shredder unattended

while it is switched on.
Before leaving the shredder, switch off

the motor and disconnect the plug. Do
likewise in the event of a power failure;
Keep children and pets away. All

onlookers should be kept a safe distance
away from the shredder when it is in use.
Do not allow children or any person who

has not read this instruction leaflet or
who is not familiar with the shredder to
operate it.
The operator is responsible for third

parties while working with the shredder.
Only use the shredder for its intended

purpose.
There are rotating blades on this

machine.
Blades do not stop immediately after

switching off.
Always switch off the shredder,

disconnect the plug and wait until the
cutting disc stops before carrying out
maintenance or cleaning work.
Use caution when cleaning or performing

maintenance on the shredder.
It is forbidden to move or modify any of

the electrical and mechanical safety
devices.
The shredder must stand on level and

solid ground during operation.
Use only in daylight or good artificial

light.
The hopper must be fitted and tightened

completely before use.
Do not put your hands into the feed

funnel or ejection slot.
During operation ensure that no foreign

objects (such as stones, glass, metal,
earth, plastics) are fed into the shredder,
these foreign objects could cause blunting
of the blades and seriously damage the
motor. Do not use your shredder for
purposes other than for its intended use.
If the shredder should start to vibrate

abnormally, switch off the motor
www.toolland.eu
immediately and check for the cause.
Vibration is generally a warning of
trouble.
Ensure blades are secure before

shredding. Do not operate the shredder if
any of the blades are not properly
mounted.
The shredder should be checked carefully

before use. You should only work with a
shredder that is in good condition. If you
notice any defect on the machine that
may cause danger to operate the
shredder until defects are rectified.
Replace worn or damaged parts for

safety. Use only original spare parts.
Parts not produced by manufacturer may
cause poor fit and possible injury.
Use the shredder only in places where it

is protected from water and never use it
outdoors in rainy weather.
Store in a dry secure place out of reach

of children.

ELECTRICAL SAFETY

Always check that the power supply
corresponds to the voltage on the rating
plate.
DESCRIPTION (FIG. A + B)
1. Feeding funnel
2. Reset button / overload protector
3. On/off switch
4. Rotational direction switch
5. Appliance plug
6. Ventilation slots
7. Undercarriage
8. Ejection Slot
9. Wheel hub
10. Wheel
11. Self-locking nuts
12. Bolts
13. Wheel axe
ASSEMBLING (FIG B)
Remove all parts from package.

Fix undercarriage (7) to the housing with

2 self-locking nuts (11) using supplied
spanner.
Mount the wheel axle (13) to the

undercarriage with 2 bolts M6x50 (12)
and nuts by using the supplied hex key
and spanner.
English
19