Bresser NATIONAL GEOGRAPHIC 9105500 Mode D'emploi page 11

Parts overview
B
ON/LIGHT/OFF-BUTTON

Discs (3 pieces)

Projection lens

Focus dial

Disc tray

Stand

Lamp (Night light/Alternating Aurora
light) (Colour morphing effect)
A
Assembly instructions
1. Insert a wing on each side (see Figure 1).
2. Insert one antenna at the top and one
antenna at the bottom (see Figure 2).
3. Place the unit in the stand (6) and then on
a flat and stable platform (e.g. a table).
The optimal projection distance is about
1.8 m to 2 m.
B
Battery installation
Only adults should insert or replace the bat-
teries.
1. Loosen the battery compartment screw
with a small Phillips screwdriver and care-
fully remove the cover.
2. Insert two AAA (LR03) batteries into the
unit with polarity as indicated on the bat-
tery compartment.
3. Close the battery compartment again.
C
Operation
1. Press the On/Light/Off button (1) once to
turn on the projector light. Dim or turn off
the light in the room for the best visual ex-
perience.
2. Press the button a second time to switch
on the lamp function (7) (Alternating Au-
rora light).
3. The third press of the button switches the
unit off. Alternatively, the light switches
off automatically after 15 minutes.
D
Turn the focus knob to focus the
image
Adjust the Focus dial (4) until the projected
star field is in focus. The image will blur if the
distance is too near or too far.
E
Rotate disc to change image
Light function
The light function is switched on by pressing
the ON/LIGHT/OFF (1) button twice and open-
ing the cover. Open the cover and admire the
play of colours on your wall or ceiling.
EN
11