Publicité
6
REMOTE CONTROL UNIT
The DVD-A11 can be controlled from a distance using the included remote control unit (RC-962).
2
(1) Inserting Batteries
q Remove the remote control unit's rear cover.
w Place two R6P/AA batteries in the battery
compartment in the direction indicated by the
marks.
e Close the rear cover.
(2) Using the Remote Control Unit
Approx. 7 meters
30°
30°
NOTES:
• It may be difficult to operate the remote control unit if the remote control sensor is exposed to direct sunlight
or strong artificial light.
• Do not press buttons on the main unit and on the remote control unit at the same time. Doing so will result
in malfunction.
Cautions On Batteries
• Use R6P/AA batteries in this remote control unit.
• Replace the batteries with new ones approximately
once a year, though this depends on the frequency
with which the remote control unit is used.
• If the remote control unit does not operate from
close to the main unit, replace the batteries with
new ones, even if less than a year has passed.
• The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do
so in the proper direction, following the < and
> marks in the remote control unit's battery
compartment.
• To prevent damage or battery fluid leakage:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or
dispose of batteries in flames.
• Remove the batteries when not planning to use
the remote control unit for a long period of time.
• If the batteries should leak, carefully wipe off the
fluid from the inside of the battery compartment,
then insert new batteries.
• When operating the remote control unit,
point it at the remote control sensor as
shown on the diagram.
• The remote control unit can be used from a
direct distance of approximately 7 meters.
This distance will be shorter, however, if
there are obstacles in the way or if the
remote control unit is not pointed directly
at the remote control sensor.
• The remote control unit can be operated at
a horizontal angle of up to 30° with respect
to the remote control sensor.
(3) Names and Functions of Remote Control Unit Buttons
2
Button not explained here function in the same way as the corresponding buttons on the main unit.
POWER ON/POWER OFF
buttons
Press this to switch the power
between on and standby.
Number buttons
Use these to input numbers.
Use the +10 button to input
numbers of 10 or over.
Example: To input 25
+10
+10
5
TOP MENU button
The top menu stored on the disc
is displayed.
ON
Cursor buttons/ENTER button
1
Use the • and ª cursor buttons
to select in the vertical direction.
4
Use the
and
cursor
0
1
buttons to select in the
7
horizontal direction.
Press the ENTER button to
0
select the item selected with
TOP MENU
the cursor buttons.
T. MENU
MENU button
The DVD menu stored on the
disc is displayed.
STOP button (
2
)
MENU
SKIP buttons
ANGLE button
Press this to switch the angle.
ANGLE
SUBTITLE button
REPEAT
Press this to switch the DVD's
subtitle language.
SETUP
A-B repeat button (A-B)
Use this to repeat sections
between two specific points.
REPEAT button
Press this to play tracks
repeatedly.
SETUP button
Press this to display the default
setting screen.
DIMMER button
Use this to adjust the brightness
of the main unit's display. Can
be switched in 4 steps, from
OFF to always on.
ZOOM button
Press this to enlarge the image.
Picture adjust button
(PIC.ADJ)
Press this to adjust the picture
quality to suit your tastes.
NTSC/PAL button
Use this to switch the set's
video output format (NTSC/PAL).
OPEN/CLOSE button
PROGRAM/DIRECT button
(PROG/DIR)
Press this to switch between
the normal play, programmed
play.
CLEAR button
Press this to clear numbers that
you have input.
OPEN /
CLOSE
POWER
NTSC / PAL
SRS.TS button
OFF
PROG / DIR
Sets the virtual surround sound.
2
3
(Functions when playing DVD-
CLEAR
videos or VCDs only. (See page
5
6
26.))
SRS.TS
8
9
RETURN button
CALL
RETURN
+ 10
Press this to return to the
DISPLAY
previous menu screen.
DISP.
DISPLAY button
Press this to display the ON-
ENTER
SCREEN.
PLAY
CALL button
STILL /
STOP
Press this to check the program
PAUSE
contents.
SKIP
SLOW / SEARCH
PLAY button (
1
SUBTITLE
AUDIO SEARCH MODE
STILL/PAUSE button (
SLOW/SEARCH buttons
A-B
RANDOM
MARKER
SEARCH MODE button
DIMMER
PIC.ADJ
Press this to change the search
ZOOM
PAGE
mode to search for groups or
titles, tracks or chapters when
selecting sections of discs
directly using the number
buttons.
RC-962
AUDIO button
For DVDs, press this to switch
the audio language. For video
CDs, press this to switch the
channel between "LR", "L" and
"R".
RANDOM button
Press this to play the tracks on
the video or music CD in random
order.
MARKER button
Press this to mark places you
want to see again.
PAGE -/PAGE + buttons
Use these to selected the
desired still picture on DVD
audio discs containing
browseable still pictures.
ENGLISH
)
3
)
13
Publicité
Chapitres
