Trip Zero Reset; Using The Intermediary Stopwatches; Consulting The Intermediary Stopwatches - Mavic WINTECH E-BOLT Mode D'emploi

14. TRIP ZERO RESET

From any screen, press the right and left buttons
simultaneously for 2 seconds to reset the following trip data
to zero:
- ATM
- DST
- Average speed
- Maximum speed
- Average cadence
- Maximum cadence
- Intermediary stopwatches

15. USING THE INTERMEDIARY STOPWATCHES

In the course of a session you can use up to 9 intermediary
stopwatches in order to evaluate your performance on
specific hills or sections.
Remember, the stopwatch only starts during a session i.e.
when the computer already indicates a speed.
From any screen in the course of a session you can press
the right button for 2 seconds to make the CR symbol flicker.
The first stopwatch (CR 1) starts when you release the right
button.
When you are using an intermediary stopwatch, the stopwatch
time replaces the ATM data in screen 3.
16
wintech-esbolt bis.indb 16 wintech-esbolt bis.indb 16
14
L R
2 sec.
L 2 sec.
To stop the first intermediary stopwatch, just press the right
button.
To start the next intermediary stopwatch (CR 2), just press
the right button for another 2 seconds, and so on for the 9
possible intermediary stopwatches.
15
R
2 sec.
16. CONSULTING THE INTERMEDIARY
STOPWATCHES
Use the left button to select screen 3 (ATM).
Press the left button for 2 seconds to display the data
corresponding to the first intermediary stopwatch (CR 1) in
loop display (2 seconds per screen): stopwatch time, distance
covered and average speed.
Briefly press the left button to switch to the next stopwatch.
Press the left button for 2 seconds to quit consultation mode
and return to normal display.
16
L
2 sec.
17
Us
Pre
(bi
(2
Th
ret
to
R
2 sec.
18
• C
c
• C
f
o
p
• S
u
• A
s
• A
a
L
d
20/03/07 12:34:21 20/03/07 12:34:21