Description - Mavic WINTECH E-BOLT Mode D'emploi

The Mavic team has put all its passion, experience and skill
into the design and manufacture of your computer.
It will be an important aid to you in the improvement of your
performance.
Thank you for putting your trust in Mavic products.
SUMMARY
1. DESCRIPTION
2. INSTALLING THE COMPUTER MOUNT
3. FITTING/REMOVING THE COMPUTER
4. INSTALLING THE SENSOR NUT
5. INSTALLING THE MAGNET
6. INSTALLING THE BATTERIES
7. DESCRIPTION OF THE DISPLAY
8. FUNCTION DISPLAY SEQUENCE
9. DIGITAL PAIRING OF THE COMPUTER
WITH THE SENSORS
10. PAIRING THE SECOND BIKE
11. SETTING THE TIME
12. SETTING THE ODOMETERS
13. SETTING THE CIRCUMFERENCE
AND THE UNIT
14. TRIP ZERO RESET
15. USING THE INTERMEDIARY STOPWATCHES
16. CONSULTING THE INTERMEDIARY
STOPWATCHES
17. CONSULTING THE DIFFERENT ODOMETERS
18. MAINTENANCE
After installation and before you use your computer for the
first time, it is IMPERATIVE to perform the digital pairing
operation described in section 9 of this guide. If you don't,
there will be no communication between the computer
and the different sensors and your system will not work.
wintech-esbolt bis.indb 11 wintech-esbolt bis.indb 11
1.2
11
11
1.3
12

1. DESCRIPTION

12
1.1 Computer
12
1.2 Sensor nut
12
1.3 Computer mount
13
1.4 25.4 handlebar mount adapter
1.5 All purpose magnet
13
1.6 Adjustment magnets
13
2. INSTALLING THE COMPUTER MOUNT
14
2.1. Install the mount on the handlebar, to the right of the
14
handlebar stem.
15
15
16
16
2.2
16
17
17
2.3.1
2.3.2
1.6
1.5
1.4
1.1
To fix it to an oversize, 31.8
diameter handlebar, just remove the
25.4 adaptor.
2.2 Install the mount on the
handlebar.
2.3 The mount can be installed
in a variety of positions: with the
computer to the fore or over the
handlebar stem.
2.4 Once you have chosen the right
position, tighten the screw with a
cross-slot screwdriver.
2.4
20/03/07 12:34:16 20/03/07 12:34:16
11