Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning,
always make sure the system has been switched off, using
the remote control, and the power supply plug has been
disconnected from the system socket (or the upstream
master isolating switch is positioned at "0" OFF).
Do not touch the metal parts of the unit when removing the air filters.
They are very sharp. Cuts or injury risk.
4.1 - CLEANING
4.1.1 - Appliance and remote control cleaning
Use a dry cloth to clean the appliance and the remote control (fig. 34).
it is possible to use a cloth moistened with cold water to clean the appliance if it is very dirty.
Suck between the air inlet and outlet grilles (fig. 34).
Do not use a chemically treated or antistatic cloth to clean the appliance.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
4.1.2 - Cleaning the air filters
In order to guarantee effective indoor air filtration and good working order of
your air conditioner, it is essential to clean the air filters periodically.
The air filters are in the left and right sides of the appliance. (Fig.31)
Filters extraction (Fig 32):
a. Switch the unit off and wait for the delivery flaps to close.
b. electrically disconnect the appliance.
c. Hold the top part of the grid (3) with two fingers.
d. Remove the grid (3). including the filter.
e. Perfectly wash and dry all the filters.
Re-mounting the filters:
f. Re-mount the grids (3) including filter. The grids (3) are fixed via magnets. (fig. 33).
to cancel the dirty filters signal, after having connected the air conditioner to the mains, simultaneously press
the Stand-by and MODE keys, present on the control panel, for at least 5 seconds (see figure B).
This way the dirty filter signal is removed and the related count is set to zero.
EN - 27
UNICO tOwer INverter
Publicité
Chapitres
Table des Matières
