Insertion Of Batteries; Replacement Of Batteries; Location Of The Remote Controller - Olimpia splendid UNICO TOWER Instructions Pour L'installation

3.4.1 - Insertion of batteries

the batteries are supplied with the machine.
To insert the batteries correctly (figure 28):
a. remove the batteries compartment cover.
b. insert the batteries into the relevant compartment.
Check the polarity indicated on the bottom of the compartment. (Fig.29)
c. Close the compartment correctly (fig. 29).

3.4.2 - Replacement of batteries

the batteries should be replaced when the display on the remote control does not appear sharply or when
the remote control does not change the settings.
Always use new batteries and replace both at the same time.
The use of old or different batteries could generate malfunctioning of the remote
control.
the remote control uses two dry alkaline 1.5V batteries (aaa.lr03).
When the batteries have been replaced, adjust the remote control clock.
When replacing batteries, replace both and dispose of the dead batteries in the
appropriate collection centres and as required by law.
• if the remote control is not used for several weeks or longer, remove the batteries.
Any leaks from the batteries could damage the remote control.
• the average life-span of the batteries, with normal use, is approx. six months. replace the batteries when
the indoor unit command receipt "beep" can no longer be heard, or if the transmission indicator on the
remote control does not switch on.
Do not re-charge or disassemble the batteries. Do not throw the batteries into the fire.
They can burn and explode.
If the battery liquid falls onto the skin or clothes, wash well with clean water. Do
not use the remote control with batteries that have leaked.
The chemical products contained in the batteries can cause burns or other risks
to health.

3.4.3 - Location of the remote controller

• Keep the remote control in a position from which the signal can reach the appliance receiver (maximum
distance is about 8 meters - with charged batteries) (fig. 30).
the presence of obstacles (furniture, curtains, walls, etc.) between the remote control and the appliance
reduces the remote control range.
EN - 20