Timer Activation And Deactivation; Reset Of All The Remote Control Functions; Managing The Unit If The Remote Control Is Not Available; Recommendations For Energy Savings - Olimpia splendid Unico Pro Mode D'emploi Et D'entretien

3.6.15 - Timer activation and deactivation

once set, the timer programs can either be activated or deactivated depending on occasional needs.
activation may relate to one of the two programs or both.
in particular, each time you press key B9 (Set timer) (Programs activation), situation changes as follows:
• Use of Program no. 1 only.
• Use of Program no. 2 only.
• Use of Programs 1 and 2.
• Disuse of both programs.

3.6.16 - Reset of all the remote control functions

replacing the batteries or removing them even for a few instants will cause all the settings of the remote
control to be reset.
in so doing, all the time settings of the timer saved in the remote control are cancelled and the remote control
restores all the factory settings.

3.6.17 - Managing the unit if the remote control is not available

in case of loss or malfunction of the remote control and/or exhaustion of the batteries, the appliance can be
controlled from the keys on board of the machine.

3.7 - RECOMMENDATIONS FOR ENERGY SAVINGS

Below find simple recommendations for reducing consumption:
• Always and constantly keep the filters clean (see maintenance and cleaning chapter).
• Keep the doors and windows of the rooms to be climate controlled closed.
• avoid the sun's rays penetrating freely into the room (we recommend using curtains or lowering blinds or
closing the shutters).
• Do not obstruct the unit air flow (inlet and outlet), i.e. in addition to bad performance of the system, it also
affects correct operation and the possibility of irreparable faults to the units.

4 - MAINTENANCE AND CLEANING

Before proceeding with any maintenance and cleaning,
always make sure the system has been switched off, using
the remote control, and the power supply plug has been
disconnected from the system socket (or the upstream
master isolating switch is positioned at "0" OFF).
Do not touch the metal parts of the unit when removing the air filters.
They are very sharp. Cuts or injury risk.
EN - 27
UNICO PRO
INVERTER