Transport, Packaging And Storage - WIKA GFU08 Mode D'emploi

5. Transport, packaging and storage

5. Transport, packaging and storage
5.1 Transport
Check the SF gas filling cart for any damage that may have been caused by transport.
6
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.Keep the packaging, as it provides
optimum protection during transport (e.g. change in operating site, sending for repair).
5.3 Storage
To store the optional components of vacuum pump or scales, the respective operating
instructions must be observed.
The SF gas filling carts are tested for fault-free functioning and packed in our factory.
6
The connections are sealed with plastic protection caps or adhesive foil.
Unless otherwise stated, the protection caps and the adhesive foils must be removed
before commissioning.
Only store the SF
■
Move the filling cart exclusively by means of the transport handle
■
Permissible conditions at the place of storage:
Storage temperature: 0 ... 60 °C
■
Humidity: 67 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
WIKA operating instructions SF
gas filling cart in an upright position
6
gas filling cart, model GFU08
6
EN
19