Cleaning The Circuit - EMS PIEZON MASTER 700 Mode D'emploi

Cleaning the circuit

"Cleaning" mode
It is recommended to wash the liquid circuit of the unit.
After 13x on/off switches with no cleaning in between a blinking LED appears in order to remind
that a cleaning of the unit is needed.
The "Cleaning" mode allows for the washing of the liquid circuit in order to reduce the crystalline
deposits in the liquid circuit. A rinsing of the circuit is then required to avoid a possible reaction caused
by the ageing of the solution or by an unwanted mixture of liquids.
All the bottles and handpiece cords used during treatment must be present during the washing of
the liquid circuit because the process is simultaneous for all these elements. Remove the handpieces
before performing a cleaning procedure.
Both connectors must be cleaned.
Circuit rinsing cycle:
• Prepare the bottle(s) with distilled or demineralized water,
• Press the "Cleaning" mode selector,
• Select the bottle(s) to use,
• Lift the connector(s) and put it (them) above a sink,
• Press the foot pedal to start the program. Three "beeps" and the blinking of the control lamp of the
Washing cycle:
• Prepare the bottle(s) with a compatible washing solution (refer to the list of compatible solutions at
the beginning of this manual),
• Select the bottle(s) to use,
• Lift the connector(s) and put it (them) above a sink,
• Press the foot pedal to start the program. Three "beeps" signal and the blinking of the control lamp
• Then allow the solution to act at least for 5 minutes without intervene with the unit.
Rinsing cycle:
• Prepare the bottle(s) with the sterile distilled water,
• Select the bottle(s) to use,
• Lift the connector(s) and put it (them) above a sink,
38
,