Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Switch (Fig. A)
To turn the unit on, depress the side of the dust-protected
switch
that corresponds to the symbol "I". To turn the
5
tool off, depress the side of the switch that corresponds to
the symbol "O".
Speed Control Dial (Fig. A)
The speed control dial
2
, shown in Figure A, allows you to
increase or decrease speed from 12000–14000 Orbits Per
Minute. The optimal speed setting for each application is
very much dependent on personal preference. Generally,
you will want to use a higher setting on harder materials
and a lower setting on softer materials. Material removal
rate increases as speed increases.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. G)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
8
pack with the rails inside the tool. Slide it in until the battery
pack is firmly seated in the tool and ensure that it does
not disengage.
To remove the battery pack from the tool, press the release
button
9
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual
Fig. G
9
8
10
into the tool, align the battery
Proper Hand Position (Fig. H)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main grip
Fig. H
6
Dust Collection (Fig. A, I)
WARNING: Collected sanding dust from sanding
surface coatings (polyurethane, linseed oil, etc.)
can self ignite in sander dust bag or elsewhere
and cause fire. To reduce risk, empty bag frequently
and strictly follow sander manual and coating
manufacturer's instructions.
Your sander has a removable dust chute
either the supplied dust bag
to be connected. The built-in outlet utilizes the D
AirLock connection making it compatible with the D
dust extractor.
To Attach the Dust Bag
1. While holding the sander, fit the dust bag collar
the removable dust chute
2. Turn the collar
12
clockwise to lock the dust bag
in place.
To Empty the Dust Bag
1. While holding the sander, turn the collar
counterclockwise to unlock the dust bag
2. Remove dust bag from the sander and gently shake or
tap the dust bag to empty.
3. Reattach the dust bag back onto the outlet and lock into
place by turning the dust bag collar clockwise.
You may notice that all the dust will not come free from
the bag. This will not affect sanding performance but will
reduce the sander's dust collection efficiency. To restore
your sander's dust collection efficiency, depress the spring
inside the dust bag when you are emptying it and tap it on
the side of the trash can or dust receptacle.
CAUTION: Never operate these tools unless the
dust collector is in place. Sanding dust exhaust may
create a breathing hazard.
6
which allows
7
or a shop vacuum system
4
WALT
e
WALT
e
12
to
7
as shown in Figure I.
4
12
4
.
.
Publicité
Table des Matières
