Engine Operation; Starting The Engine - Shindaiwa EB262 Manuel D'utilisation

Engine operation

Starting the engine

 When starting the engine, observe the precautions described from Page 4 in the section "For safe use of your prod-
uct" to ensure that you operate the product correctly.
 Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
NOTE
 Pull out the starter grip gently at first, and then more rapidly. Do not pull the starter rope out to more than 2/3 of its length.
 Do not let go of the starter grip as it returns.
 To start the engine, return the choke knob when you hear the first explosion-like sound and pull on the starter grip again. Be
careful not to miss the first explosion-like sound.
Starting a cold engine
1. Stop switch
1. Choke
1. Recoil starter
1. Choke
WARNING
2. Throttle position lever
2. Purge bulb
Engine operation
 Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the
unit firmly.
1. Stop Switch
Move stop switch away from the STOP position.
2. Throttle Position Lever
Move throttle position lever midway between idle and full
throttle positions.
3. Choke
Move choke lever to "
4. Purge Bulb
Pump purge bulb until fuel is visible and flows freely in the
clear fuel tank return line.
5. Recoil Starter
Place the blower on a flat, clear area. Hold the blower firmly
with left hand and pull out the starter grip gently at first, and
rapidly pull recoil starter handle/rope until engine fires, or
maximum 5 pulls.
6. Choke
Move choke lever to "
engine.If engine does not start after 5 pulls, repeat instruc-
tions 3-6.
7. Engine start
Allow engine to warm up before use.
16
" position.
" position and if necessary, restart