Smart Cable LED and Alarm Behavior
BEHAVIOR
Green LED blinking; Red LED
off; no beep.
Green LED solid; Red LED off;
no beep.
Solid Red LED, Green LED off;
beeps once per second
Solid Red LED, Green LED off;
beeps twice per second
Alternating Red and Green
flashing LEDs; no beep
Solid Red LED, Green LED off;
rapid beeping
Solid Red and Green LEDs;
no beep.
Solid Red and Green LEDs;
beeps once per second
NOTE: When the condition is corrected, the smart cable will automatically reset.
11. BEFORE RETURNING FOR REPAIRS
If these solutions do not eliminate the problem,
or for more information about troubleshooting, call:
Schumacher Electric Corporation Customer Service
12. SPECIFICATIONS
Internal battery type .......................................... Lithium ion polymer
Charger ................................................100V~240V AC wall charger
Capacity ............................................................8,000 mAh/29.6 Wh
USB output .............................................................5V DC, 2.1A / 1A
Jump start ................................................400A peak/200A cranking
Charging Temperature..................................... 32 ° -122 ° F (0 ° -50 ° C)
13. REPLACEMENT PARTS
Battery clamp smart cable ....................... 94500883Z or 94500859Z
AC wall charger .......................................................... 3899003549Z
1-800-621-5485
Return products under warranty
to your local NAPA Auto Parts Store.
Cable is connected to battery only.
Cable is connected to jump starter only.
Cable is connected correctly to both
battery and jump starter.
Low voltage protection
Reverse polarity protection
Reverse charging protection
Short circuit protection
Auto shut-off, due to inactivity. Disconnect
and reconnect clamps to the vehicle battery.
Temperature protection
• 11 •
REASON