Care And Maintenance - Cleaning Lenses; Optional Accessories; Dmx Technology - Cameo F1 Manuel D'utilisation

CARE AND MAINTENANCE – CLEANING LENSES
The front lens (E) and its rubber frame can be cleaned by flipping the retaining
bracket upwards as previously described and then drawing the front lens and its
rubber frame as well as the filter frame upwards out of the retention arms. Clean
the front lens with a moist, lint-free cloth, making sure not to scratch the surface of
the lens. Do not put the front lens and filter frame back into the support arms until
all equipment and accessories are completely dry. Then return the retaining bracket
back to its downward position until the lock pins click into place.
E

OPTIONAL ACCESSORIES

A mounting plate with V-mount adapter and connection cable for an external standard 14.4 or 14.8 volt V-mount battery is optionally
available.
Article number: CLF1VMOUNTAP

DMX TECHNOLOGY

DMX-512
DMX (Digital Multiplex) is the designation for a universal transmission protocol for
communications between corresponding devices and controllers. A DMX controller sends
DMX data to the connected DMX device(s). The DMX data is always transmitted as a serial
data stream that is forwarded from one connected device to the next via the "DMX IN" and
"DMX OUT" connectors (XLR plug-type connectors) that are found on every DMX-capable
device, provided the maximum number of devices does not exceed 32 units. The last device
in the chain needs to be equipped with a terminator (terminating resistor).
DMX CONNECTION
DMX is the common "language" via which a very wide range of types and models of equipment from various manufacturers can
be connected with one another and controlled via a central controller, provided that all of the devices and the controller are DMX
compatible. For optimum data transmission, it is necessary to keep the connecting cables between the individual devices as short as
possible. The order in which the devices are integrated in the DMX network has no influence on the addresses. Thus the device with
the DMX address 1 can be located at any position in the (serial) DMX chain: at the beginning, at the end or somewhere in the middle.
If the DMX address 1 is assigned to a device, the controller "knows" that it should send all data allocated to address 1 to this device
regardless of its position in the DMX network.
16