Jydepejsen Zeta Mode D'emploi page 22

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
It is important to keep the door closed when flames are visible in the fire chamber to avoid smoke nuisances in the
room.
1. Turn the air wheel to the maximum.
2. To minimize the underpressure, the door should be ajar for about one minute before you open it
completely.
3. Open the door slowly.
4. Add about 3 pieces, about 2,1 kg. in total, of firewood to the combustion chamber.
Maximum fill height: 155 mm. (to the line in the fire chamber)
5. Close the door.
6. Turn down the air supply when the fire has caught the wood, to obtain steady and calm flames.
Nominal yield is achieved at approximately 60% air after 3 minutes with a flue uptake of 12 Pa.
5. Maintenance
Sealing bands and vermiculite plates are wearing parts and should be replaced as needed. How often depends of the use
of the stove - some stove owners have to change the parts every year whereas others replace them every two or three
years. Sealing bands should be replaced when flat and the front door is no longer tight. New sealing bands with glue may
be ordered from your wood-burning stove dealer.
The vermiculite plates should be replaced when they appear worn or have deep scratches revealing the fire chamber steel.
Worn vermiculite plates should be replaced in time as they will otherwise loose their heat reflection and insulation
properties. Movable and mechanical parts should be greased with a heat-resistant lubricant at least every year (locking
mechanism, hinges, etc.)
The stove and the chimney should be checked regularly by a qualified professional to ensure the optimal function of the
stove. It is illegal to make unauthorized changes to wood-burning stoves and doing so will void the warranty and the test
results.
Renewal of the sealing band at the door
1. Remove the sealing band from the inner frame and clean the band mark (it is not necessary to remove
the door from the stove).
2. Add a band of heat-resistant glue on the band mark.
3. Push new sealing band down into the mark.
4. Close the door and let the glue harden for about 24 hours, before you open the door again. If you do
not let the glue harden sufficiently before you open the door, the band may fall out.
Change of the vermiculite panels
1. Place the rear panel.
2. Place the side panels.
3. Place the bottom panel.
4. Place the baffle plate on top of the rear panel panels.
Change of the vermiculite panels takes place in the opposite
order.
Jydepejsen A/S – August 2018

Publicité

Table des Matières
loading

Table des Matières