babymoov A002028 Notice D'utilisation page 9

7. The bottle-warmer turns off automatically when the heating cycle is over. At the same time, the backlight ring (h) will turn green
for a minute, which means that the bottle is ready.
Take out the bottle or jar straight away with a pair of tongs or a cloth as they are hot.
To avoid the risk of burns, always check the temperature of the food before giving it to your baby. If you are using a baby bottle,
shake it well to mix the milk. Pour a drop onto the inside of your
wrist to check how warm it is. If you are using a jar, mix the contents and taste it to make sure it is not too hot.
Using the appliance in the car
Stop the vehicle and let the engine running.
8. Put the bottle-warmer on a flat and steady surface inside your vehicle. Plug the cigarette-lighter adapter (f) into to the bottle-
warmer's power cable (g).
9. Plug the adapter (f) into the cigarette-lighter. Fill up the measuring device (a) with water by following the doses reported here
below and then pour the water into the warming tank (b).
Repeat the steps above, from 3 to 7.
Amount of water
in the baby bottle
60 ml
90 ml
120 ml
150 ml
180 ml
210 ml
240 ml
270 ml
300 ml
330 ml
Cleaning:
- Wait until the bottle warmer is cold before cleaning it.
- Always unplug the appliance before cleaning it.
- Never submerge the appliance in water, and don't fill it right up with water.
- Never use detergents to clean the appliance.
- Use a slightly damp cloth to clean the inside and outside.
- Adaptor ring, measure and baskets for jars can be washed in the dishwasher.
De-scaling:
Do not use any de-scaling products. Depending on the quality of water used and after a certain period of time, a layer of scale may
build up in the tank (b). In order for the sterilizer to work properly, the tank needs to be de-scaled regularly.
Proceed as follows: Mix 100 ml hot water with 100 ml white vinegar and pour it all into the tank (b). Leave to act for 30 minutes then
empty the appliance. Then use a damp cloth to clean it.
The bottle warmer doesn't heat up:
- check the "On" button to make sure it is properly switched on,
- check that the appliance is properly plugged in,
- check that there is not too much scale in the tank, and de-scale if necessary.
The warming cycles are too short or too long:
too much or too little water used. Adjust the quantity of water according to the temperature you want:
more water = hotter
less water = cooler
Amount of water to put
in the measuring device
for a baby bottle
prepared with
warm water
4 ml
5 ml
5 ml
5 ml
5 ml
5,5 ml
5,5 ml
6 ml
6,5 ml
6,5 ml
MAINTENANCE
IN CASE OF ANY LITTLE PROBLEMS
TULIPE HOME/CAR BOTTLE-WARMER • Instructions for use
Amount of water
Jar to put in the measuring
device for a jar
120 g
200 g
250 g
9 ml
12 ml
14 ml
9