Beper 50.943 Manuel D'instructions page 10

Dry Iron Use instructions
If you decide not to use the appliance any longer, make it unserviceable by simply cutting the supply
cable after disconnecting the plug from the socket. Also make any dangerous parts unserviceable,
especially for children who could play whit the appliance.
Let other potential users read these instructions.
Keep these instructions.
USE ADVICE
Make sure that the mains voltage corresponds to the data specified on the label.
Do not used the iron if the cord supply or plug are damaged or in case of electric shock make it
repaired by an authorized assistance centre.
When using the iron for the first time remove the protection on the soleplate.
When used for the first time the soleplate may diffuse a light smoke caused by evaporation of pro-
tective oil used in factory ; that is not dangerous and smoke will disappear after some use.
Never pull the supply cord to unplug the appliance.
Do not roll up the electric cord around the iron.
Keep away to a reasonable distance the supply cord from the iron plate, especially when it is hot.
When making a break or if not used, put the iron on the iron rest in vertical position.
The plate of the iron becomes very hot, take care not to burn yourself.
Always choose the right temperature according the cloth which has to be ironed.
Do not use the stream station as a heater. Do not iron the wet clothes, let them dry before ironing.
Do not pass the iron on buttons or zipper in order to not to damage the plate.
Before cleaning, unplug the supply cord.
If you no longer use this appliance, please keep away from children.
INSTRUCTION FOR USE
When used for the first time a little smoke may appear but will stop after a few minutes.
Before using the iron remove adhesive or protective film from the soleplate using if necessary a wet
cloth.
Do not scratch the soleplate with metallic object, as well as zip, buttons, etc.
Before plugging the iron on the socket, check that the main voltage correspond to the one used for
the iron.
ATTENTION: THE SOLEPLATE IS VERY HOT, DO NOT TOUCH DURING USE !
KEEP AWAY FROM CHILDREN.
IRONING
1 – Set the temperatureon "MIN".
2 – Place the iron in vertical position, the soleplate does not be in contact with objects or other.
3 – Plug the appliance to the socket.
4 – Set the desired temperature, using symbols on the thermostat.
5 – Start ironing.
6 – After ironing, put the iron in vertical position and unplug the appliance.
The iron must always in movement on the fabric when used.
10