When To Change The Thread Lifters; How To Replace The Thread Lifters; Cleaning The Roller On The Allteq Floorhead; Cleaning And Care - Miele Blizzard CX1 Mode D'emploi

Masquer les pouces Voir aussi pour Blizzard CX1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

 Press the ComfortClean button on
the vacuum cleaner for at least four
seconds (dia. 31).
The vacuum cleaner can continue to be
used in this way, but only at maximum
power.
 Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
 Replace the battery with a new one,
making sure the polarity is correct.
 Replace the cover and tighten the
screw back up again.
 Dispose of the old battery in a desig-
nated recycling bin for batteries.
Keep batteries out of the reach
of children.
A swallowed battery can cause injury
and even death. Even flat batteries
can still be dangerous. If you suspect
a child has swallowed a battery, seek
medical advice immediately*. Exam-
ine devices and make sure the bat-
tery compartment is correctly se-
cured, e.g. that the screw or other
mechanical fastener is tightened. Do
not use if compartment is not secure.
* Australia: Poisons Information
Centre, Tel. 13 11 26;
NZ: National Poisons Centre,
Tel. 0800 764 766

When to change the thread lifters

(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters

(dia. 33)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 34)
 Release the bearing (with bayonet fit-
ting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele Dealer or from Miele (see
end of booklet for contact details).

Cleaning and care

Always disconnect the vacuum
cleaner from the power supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and plastic ac-
cessories can be cleaned using a
standard domestic cleaning agent suit-
able for plastic.
en
45

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3916Blizzard cx1 sk sérieHs16

Table des Matières