When To Change The Thread Lifters; How To Replace The Thread Lifters; Cleaning And Care - Miele Complete C3 Electro Plus Mode D'emploi

When using the AirClean filter please
note
An AirClean exhaust filter is supplied
with every packet of Miele dustbags. If
you wish to use this filter it is essential
that you use a filter grille (see "Optional
accessories").

When to change the thread lifters

The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters

(dia. 31)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Fit new thread lifters.
Replacement parts are available from
your Miele Dealer or from Miele (see
end of booklet for contact details).

Cleaning and care


Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.

Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents.
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.

Do not let the vacuum cleaner
get wet. If moisture gets into the ap-
pliance, there is a risk of electric
shock.
en
45